Step One: Make sure that your curling wand is set anywhere from degrees if your extensions are synthetic. If you exceed this temperature, you risk melting the synthetic fibers! It's important to remember not to use a regular hairbrush on alternative hair, instead use a wide tooth wig comb! Step Two: Next, get the hair extensions ready for styling.
Remember not to style the extensions before putting in! Using a Styrofoam head and T-Pins, pin your hair extensions to the Styrofoam head so that the hair extensions will stay secure while curling.
Step Three: Once the curling wand has warmed up to the correct temperature, wrap small portions of the hair around the curling wand and hold for seconds. Step Four: Clip it to cool it! Remove the curling wand, but keep the coiled hair in place until it cools using a clip or your fingers. This step is crucial in ensuring that the synthetic hair holds the curl! Repeat these three steps until you have beautifully curled hair extensions!
Continue Shopping. Your cart is currently empty. Click here to continue shopping. November 19, When curling your synthetic pieces synthetic wigs, clip in ponytails, hair extensions , etc, we recommend not surpassing degrees fahrenheit as just like with real hair - this could cause some damage aka melting.
Use a claw clip or pins and attach to a towel rack or something stable to make the job a lot easier. For curling technique, curl as you would your normal hair. Moisturize your synthetic hair.
Squirt a little cream-based moisturizer onto the palm of your hand. Rub your hands together and run the moisturizer through your synthetic hair. The moisturizer will help the synthetic hair hold the curl.
You can also use an olive oil in place of the cream moisturizer. Roll your hair onto perm rods. Determine how large you'd like your curls and lay out several sizes of perm rods. Divide your hair into a small section and roll it up and onto a perm rod. Cap the end so the hair stays tightly wound on the rod. Do this until you've rolled all of your hair onto perm rods. Try to vary the sizes of the perm rods to get different sizes of curls.
For a more natural look, keep the curls near your neck and the back of your head larger and looser. Use smaller perm rods for the curls near your face so they're smaller and tighter. Dip the perm rods in hot water. Carefully, dip each perm rod with hair into the hot water and hold it in the mug for about 15 to 20 seconds.
Lift the perm rod out and dip each of the other perm rods in one at a time. Always use caution when handling hot water. If the mug is too hot to handle, wait till it's comfortable to pick up with your bare hands.
Let the hair dry. Keep the hair in the perm rods and let them cool and dry completely. They may dry quickly or take a full day to dry, depending on how much hair you wrapped on each curling rod. If you want to sleep with the perm rods in so your curls set overnight, just wear a protective cap.
If you're short on time, you could blow dry the hair. Just ensure that the blow dryer is on the lowest setting.
Remove the perm rods. Once the hair has dried completely around the perm rods, gently remove them. The curls will probably be tight and springy when pulled. If you'd like them to stay tight and close to your head, just leave them alone.
If you'd like the curls to look softer or fluffier, run your fingers through your hair. You can also separate curls into smaller ones. This can make them look softer and add volume to your hair. Method 3. Divide and straighten a small section of hair. Gather a small section of your hair and brush it to remove any tangles. Turn on a flat iron to the lowest setting usually around degrees F and once it's warm, run it through the strand.
Continue running the flat iron over the section of hair until the section is smooth and straight. For many small curls, keep the sections small. You should also make sure the sections aren't too large or the pin clips won't be able to hold the hair. Use a flat iron to curl the hair.
With the flat iron on the lowest setting, run it through the straight strand of hair. Wind the hair backwards away from your face so that the strand curls onto the flat iron. Do this slowly so that the hair curls.
Keep the temperature of the flat iron low so that it doesn't melt your synthetic hair. You're just getting a basic curl shape that you'll wind and pin to your head. Pin the curl to your head. While the curl is still warm, wrap it tightly around your index finger. Gently slide the curl off of your finger and hold it between your thumb and index finger.
The curl will look like a flat, circular twist of hair. Bring the curl to your scalp and pin it to your head using a small metal hair clip.
Pin the rest of your hair and let the curls sit overnight. Straighten, curl and pin the rest of your hair.
You may find it easier to curl and pin the hair closest to your temples if curling a weave.
0コメント